[. . . ] Das M-218S Modul wird einfach am Front-Modulslot eines P-Amps eingesteckt und übernimmt dann ohne große Justiermaßnahmen die Kontrolle der angeschlossenen Systemkomponenten. Ein Abgleich der Lautstärke ist über den Präzisions- Levelregler mit 31 Raststellungen möglich. [. . . ] Adjusting the volume is possible via a precision 31-step level rotary control. The 24dB LR-Lo-Pass filter's crossover frequency is set to 100Hz. The integrated, patented LPN (LOW PASS NOTCH) filter, which optimally matches the transmission function of the Rx-218S cabinet, allows linearizing frequency and phase responses of the connected speaker system. The signal-present LED lights when an audio signal with a level of at least -35dBu is present on the module or power amplifier input. P-Amps are capable of producing peak output that exceeds the stated nominal output capacity by far. VCP simulates the thermal behavior of the connected loudspeaker systems, limiting the energy that is fed to the speakers during continuous overload situations. Turning off the VCP-function is possible using the VCP-OFF switch on the module's printed board assembly. Setting the "MODE SELECTOR" switch on the M-218S module's printed board assembly to its "1in2"-position allows parallel operation of the power amplifier blocks A&B of a Dual Channel power amp, e. g. the P1202, bearing the advantage that the two channels use only one filter module. The second module slot stays empty. Description Le M-218S est un module de traitement du signal destiné aux systèmes P-Amp, spécialement conçu pour être utilisé avec des subwoofers. [. . . ] Lorsque le commutateur "MODE SELECTOR" situé sur le circuit imprimé du module M-218S est réglé sur "1in2", les blocs de puissance A&B d'un amplificateur de puissance à deux canaux - par exemple, le P1202, sont configurés pour un fonctionnement en parallèle. Dans ce cas, un seul module de filtre est nécessaire pour les deux canaux, et le second slot pour module reste libre. BLOCK DIAGRAM M-218S Specifications M-218S Module measured in Amplifier P1202, no load, level control in center position, unless otherwise specified. [. . . ]